Eml on after fitting alternator?
#1
Scooby Regular
Thread Starter
Join Date: Jul 2012
Location: Dewsbury (West Yorkshire)
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Eml on after fitting alternator?
Hi, I've just had my alternator repaired on my 2004 blob sti as it was only charging at 12v... So Ive fitted it back on and now it's charging at 14v.. Job done!. After checking the charge I get into the car and find the eml is on? So I get the code reader out and there's a list of faults as long as my arm and they won't erase. I'm confused. The battery voltage has been low as I noticed it didn't start very good this morning but it starts perfect now so I kno there's charge in the battery again. Car drives perfect even tho eml is on and showing a load of faults. Anyone got any ideas as it's bugging me not knowing? Thanks Paul
#3
Scooby Regular
Thread Starter
Join Date: Jul 2012
Location: Dewsbury (West Yorkshire)
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I had it repaired and he changed the regulator which is the part where the electric connector goes on.... I think he's fitted the wrong one as I've read classics have a 3 pin connector but only 2 pins are used and newage use all 3 pins with the 3rd pin been for the smart charge
#4
Scooby Regular
Thread Starter
Join Date: Jul 2012
Location: Dewsbury (West Yorkshire)
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I bet there was nowt wrong with the alternator to begin with cos it was charging at 12.2v and I thought that was low but apparently that's not too bad wen lights aren't on. I'm thinking possibly the battery now
#7
Scooby Regular
Thread Starter
Join Date: Jul 2012
Location: Dewsbury (West Yorkshire)
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Will see tmoro wen I've to take it off again and take it back to them. Luckily it's only a 2min job to take off but I've possibly just wasted my money getting it repaired wen I didn't need to lol
Trending Topics
#9
Scooby Regular
Thread Starter
Join Date: Jul 2012
Location: Dewsbury (West Yorkshire)
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Sorted I think.. Got the old regulator put in and changed the battery and light is off now but wen I put the laptop on to the clear the codes they still wouldn't erase? But the light has stayed off and I've taken it for a good run and seems fine.. May have to get the other diagnostic tool out at work tmoro and have a play
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM