engine manigment light on
11 December 2010, 11:06 PM
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: May 2007
Location: halifax
Posts: 540
Likes: 0
Received 0 Likes
on
0 Posts
engine manigment light on
what can cause the engine manigment light to stay on for about 3 min's when engine is started then go out,? is this start of a problem and if so what could cause this, am a bit worried now
11 December 2010, 11:26 PM
#2
Hi there if you have Bugeye/Blobeye WRX(bugeye WRX have worst/sensitive camshaft sensor) and if you are hitting the rev limiter for few times ecu will trigger CEL-check engine light and after few starts will disappear....
This is common faults/error on Bugeye WRX...
And again if you have someone with obd reader will be good to find which error code has been(this code will be stored like historic code in ECU)
This is common faults/error on Bugeye WRX...
And again if you have someone with obd reader will be good to find which error code has been(this code will be stored like historic code in ECU)
12 December 2010, 01:12 AM
#3
Scooby Regular
iTrader: (12)
Join Date: Jan 2009
Location: Co. Durham
Posts: 2,291
Likes: 0
Received 0 Likes
on
0 Posts
There is only one way to find out whats causing it... plug in the two leads under the steering column and get the fault code (thats if you have a classic)
Thread
Thread Starter
Forum
Replies
Last Post
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM