Fitting Autometer AFR gauge.

20 June 2001, 13:07

Just bought an Autometer Air Fuel Ratio Gauge.

Anybody fitted one of these before? If so, could you tell me where you wired it in?

Instructions state the Red wire should go to 5amp fused 12v supply, Black to good engine earth and purple to O2 sensor (is that the one in the downpipe?) According to the bbok these should go into the harness.

Any help gratefully received.

James.

24 June 2001, 00:08

Erm... Help?

24 June 2001, 17:50

James,

Where did you buy yours from and what did it cost you? Also, what colour is the face and the bezel? Mail me if you want.

Sorry I can't help.... if I find out I'll let you know.

Cheers, Houlbt

24 June 2001, 19:13

James
i've got one of these fitted
it is the sensor on the downpipe, it's the wire that is shielded, its easy to tell which one when you have a look, the positive and negative wires i wired in under the dashboard to a live when ignition on
let us know if you need any more help
simon

25 June 2001, 08:05

Cheers Simon.

Houblt, Gauge is White Faced (Autometer Phantom) and came from

27 June 2001, 16:02

James.
Sorry, I've only just seen the thread.
If you get stuck, call Elvis at TN as he fitted mine. 01604 588599.

Stef.

28 June 2001, 12:23

James,

The positive an earth r self explanitory,
the purple goes to the signal wire from u r lambda sensor who`s position on the ECU loom depends on what YM of scoob u have. If u have an early model an get stuck gimme a shout

Pete

28 June 2001, 18:19

James

Have a word with Mike at Scoobymania, he supplied and fitted mine. It definately went into the loom by the ecu, but thats all i know i`m afraid.

Cheers
Paul

29 June 2001, 00:38

Thanks for the info folks