Hi All,
Head gasket is likly got a slight blow - oil to water - small amount of creamy cr@p in the tank, nothing to bad.
Replacing the rad tomorrow which is the likely cause of the problem.
Are any od the pour-in type remedies any good?
My main issue is that the blow will push whatever sealant i put in away as the oil is under pressure and blowing into the water if you see what i mean
The car in question is my old Pug 406 TD sh*tter worth not a lot so do not want to spend good money after bad.
The car needs to last for 12 months or so and around 12k miles and i will likely scrap it.
some of the prods
RxAuto Head Gasket Repair | Blown Head Gasket | Call 1-866-780-9042
Bar's Leaks Head Gasket Repair
Steel Seal- RETAIL CUSTOMERS
Any reccomendations or any to steer away from?
I know i could poist in OM but is it a general question about this stuff rather than car specific if you see what i mean.