CHUCKblue

Hi guys,

Is it a big job to replace a broken abs ring? Where do I get the parts? What is involved?

Also I have a pair where can I buy sliding pins, new pistons, seals for bug eye four pots?

Cheers

Dan

danny c

iTrader: (6)

you will have to buy a cv joint as abs ring comes complete! iv never known them to come seperate! not to much of a job if your used to getting your hands dirty!
godspeed on here will be able to sort you out for your brakes!

CHUCKblue

If I get one second hand what would need to come off to get it on? Do I need to take the bearing apart?

danny c

iTrader: (6)

no just undo the hub nut and cv joint will come out of the bearing! you are better off getting a second hand driveshaft,its easier that messing about with cv boots etc!
you will need to take wheel off,undo hub nut,undo bottom ball joint bolt and split ball joint,then u can pull hub out and pull cv joint out through the hub and bearing,knock roll pin out of the gearbox side and pull other end of shaft off!

CHUCKblue

Thanks Danny.

Does anyone know whether the abs ring is the same as on other models?

mike wrx

hi got my rear abs tone ring replaced last weekend lol

got mine new from importcarparts think was about 50 quid

swrtno1

iTrader: (2)

Nothing worse than a broken ring!!

chunksta

hi guys i got told that i can buy a non abs drive shaft and pull the abs ring off my drive shaft and put it on the non abs drive shaft but then got told by someone els the abs ring is on the hub not the shaft any one can help