rudi93

iTrader: (22)

hi all, does anyone have a list of the fault code for the abs on a my93..
i ask because ive done a fault check and its come up with 11,25,26,42.
i think the 11 is the start code and 42 end code but what sensors are 25,26???
any help would be great peeps

gfunk-legacy

hi just Google
subaru fault codes
or flash codes
this might help
mark

http://www.troublecodes.net/Subaru/

rudi93

iTrader: (22)

11 – Start Code, DTC is shown after start code, Only start code is shown in normal condition

Abnormal ABS sensor, open circuit or voltage too high
21 – front right ABS sensor
23 – front left ABS sensor
25 – rear right ABS sensor
27 – rear left ABS sensor

Abnormal ABS sensor, abnormal ABS sensor signal
22 – front right ABS sensor
24 – front left ABS sensor
26 – rear right ABS sensor
28 – rear left ABS sensor
29 – any one of four

Abnormal solenoid valve circuits in ABS control module and hydraulic unit
31 – Front right inlet valve
32 – Front right outlet valve
33 – Front left inlet valve
34 – Front left outlet valve
35 – Rear right inlet valve
36 – Rear right outlet valve
37 – Rear left inlet valve
38 – Rear left outlet valve

41 – Abnormal ABS control module
42 – Source voltage is abnormal
44 – A combination of AT control abnormal
51 – Abnormal valve relay
52 – Abnormal motor and/or motor relay
54 – Abnormal stop light switch
56 – Abnormal G sensor output voltage

--------------------------------------------------------------------------------